Start D:\Ham\HDSDR\HDSDR.exe D:\Ham\HDSDR\ExtIO_SDRplay_RSP1A.
Hrd connect serial#
(Note that your installation directories will vary.): # Launch the VSPE with the saved parameters (WR9R.vspe)Ĭd "C:\Program Files\\Virtual Serial Ports Emulator (64 bit)" With the batch file in place, you can add a shortcut to the start menu for a 1-click launch. To keep the process of starting up my station clean and simple, I use a batch file to launch the applications. The settings retain you need not repeat these steps. HDSDR supports a basic Kenwood protocol and I found that the TS-440S seemed to work well. Next, Ham Radio Deluxe is then configured to connect through the VSPE-pair to HDSDR using COM12. The HDSDR is controlled over CAT via COM11: (My FT-991a uses COM17 for CAT control):īecause the PTT (Transmit) will be going from HRD to HDSDR to the FT-991a, the TX path must be setup in HDSDR: Firstly, HDSDR controls the actual rig, so OmniRig is configured accordingly. The HDSDR connections are possible once VSPE is running with the “pair” in place. (COM21 and up do not seem to work with OmniRig.) These settings were save to WR9R.vspe for easy access. I chose to use COM11 and COM12, but any ports below COM21 will work as long as they don’t collide with any other ports of the same name.
Hrd connect install#
Step one was to install VSPE and create the “Pair” of virtual ports that will connect HRD with HDSDR. I purchased the EterLogics VSPE software because it’s inexpensive, and it works great. EterLogic’s Virtual Serial Ports Emulator (VSPE) software then allows HRD to “rig control” HDSDR, which in-turn controls the FT-991a. In my setup which is similar as is in the SDRplay document, I connect HDSDR to my Yeasu FT-991a through its OmniRig interface. SDRuno and HDSDR software are common in that both use OmniRig as the connecting data system to communicate between applications and rigs.
Hrd connect how to#
During my studies of SDR and acquisition of an SDRplay RSP1a, I learned how to refurbish virtual serial ports into connectors. Remember that Communications between the Flex Radio and other programs is handled via Virtual Connections through software on PC. Make sure your radio is powered on and connected to the PC via the Firewire cable. Running Ham Radio Deluxe (HRD) as my go-to logging system, rig control, and digital-modes manager, creates the foundation for what everything else would hopefully connect to. HAM Radio Deluxe Setup for FLEX Before you can connect to HRD you must first setup the PowerSDR software that runs the Flex Radio. The setup described here is more about maximizing the performance and ease-of-use of my basement-shack when operating it locally. It was during this effort that a lot of research went into finding the simplest ways to connect ham-shack-devices.
In a previous post, my goal was to be able to operate my basement station remotely from our three-season room. Getting to a somewhat clean setup with minimal patches is a challenge. So it is common to find stations made up of several small solutions roped together via adapters and cables.
Makers and problem solvers have always made up amateur radio. In our heavily digital world there are some expectations with respect to the interoperability of devices and software.